Maximum Muscle Trainer Wall-Mounted Pull Up Chin Up Bar

The bar itself is great. The mounting instructions could use some work, though. They assume you''re going to use screw anchors to mount it in wallboard, and I''m not convinced. Since the mounting holes are not on 16" centers I bolted the pullup bar itself to a 2x10x36" board using 1/4" nuts and bolts and then used 1/4" lag screws to screw the board to 3 studs, 3 screws per stud. After all that it''s pretty solidly mounted, but it took some work.

It''s a very sturdy pull up bar once you get it installed. If you are putting this up on a brick wall you will have no problem with installing it. However, if you plan on using studs on a wall, you better pack a lunch. Most studs are separated by sixteen inches. The design of this product is flawed because the wall support frame is between 12 and 15 inches. I ended up putting this up in a different location than i wanted too because of this problem.

Buy Maximum Muscle Trainer Wall-Mounted Pull Up Chin Up Bar Now

This bar works great once you have it set-up. The set-up is very difficult as the holes to put the bolts to attach it to the wall through are not 16 inches apart like most studs in a house so I needed to drill two 2*4''s across the studs so that I had something secure to attach the bar to. The drywall attachment did not work as the bar pulled right out of the wall. Once I had it set-up it worked great though.

Read Best Reviews of Maximum Muscle Trainer Wall-Mounted Pull Up Chin Up Bar Here

This was exactly what I wanted...and the price was awesome compared to other pull up bars ranging from $100-$200. I have a concrete wall and it mounted just fine after drilling a few holes. It comes with nuts & bolts, washers, and nylon plugs for after you drill holes in the wall. The bolts that go into the wall are roughly 3 to 4 inches, so it does hold up pretty well. I used a 3/8" for my drillbit when drilling holes. Make sure you have a wrench or at least a set of pliers because these are bolts, not screws(you can''t use a phillips or flathead screwdriver on them). Definitely a good buy for its price considering it is a pull up bar AND a dipping station.

Want Maximum Muscle Trainer Wall-Mounted Pull Up Chin Up Bar Discount?

Not hard to mount and plenty strong for me at 180 lbs. The rubber grips on the end would rotate easily and the black finish on the side bars is way too slippery to hold on to while doing pullups. I wrapped it with sticky athletic tape now it works great.

Save 28% off