I promised that I would update this review and someone asked recently about measurements. So, with that in mind I measured the pull up bar. It would work in a doorway that is between 36 inches and 42 inches. If your doorway is smaller then 36 inches or wider then 42 inches, do not bother. My doorway is smaller then 36 inches and even though I was able to put spacer blocks on each end of the bar that goes against the wall, I would not recommend doing this. Just be aware of the opening if it is not within the measurements given, then, do not bother with this or any other doorway pull up bar.
REASON FOR SPACER BLOCKS:
I installed the spacer blocks because there is a small piece of tubing that sticks out the back side of the bar. This tubing was damaging the molding around the doorway, by adding the spacer blocks I was able to keep the tubing from damaging the molding.
Look at the picture of the pull up or chin up bar. You will see a flat horizontal bar that goes on the back side of the doorway and rests on the molding above the door (this is the highest bar in the picture). Below that you will see the longer horizontal tube (or bar) which goes on the outside of the doorway and comes in contact with the molding on either side of the doorway.
ONE OTHER NOTE: If you are living in a new home, manufactured home, trailer, or some modular homes there is a chance the interior walls may have been built with 2 X 3 studs. If this is the case the walls are thinner then if they were built using 2 X 4 studs, this too can cause issues with the bar not fitting properly and possibly damaging the molding on the side of the door which the flat horizontal bar rests on. I cannot say for certain if using the optional mounting brackets would solve this problem. But my best guess is that it very well would allow you to use the bar on a wall built with 2 X 3 studs.
ORIGINAL REVIEW FOLLOWS:
First let me say my rating of two starts is meant for the lack of information and the picture instructions. I am a technical writer, so calling an exploded view picture with a bunch of letters an instruction is offensive to me.
But let me clear up what I mean of lack of information first. All vendors market this bar as it will fit MOST doorways. That maybe so, but how hard is it to measure the bar and flatly give the maximum and minimum doorway widths in which this bar can be used. I have a friend who lives in an old farm house with huge doorway openings the bar simply can not grab onto the casing it passes through the opening. In my case, the opening is too narrow and the bar will damage my walls. I will go back and measure the bar, and if I am able I will update this review to include dimensions so no one else has to go through this.
Instructions or lack there of. OK, I assemble things, and write about how to put them together. I have never taken a picture or provided an exploded view of a product that included the hardware in the picture then expected any one to know how to assemble the product. But this is what they do with this product. It is not extremely difficult to figure out, just a little annoying and a couple of assembly hints would be nice.
Assembly hints:
You will need a large screw driver with either a Phillips head or a flat tip. A small tipped screw driver will only be a cause for frustration. You will also need a small 10 mm socket. No, a box end, open end, adjustable wrench. These will get you started but in at least three locations once the nut gets close enough to the tubing, these wrenches will not be able to hold onto the nut and you will not be able to fully tighten them.
It comes with an optional set of mounting brackets. Which I will be installing, but there is no explanation as to why you may want to choose to install them. I am going to install them, because if I don''t the bar will be so low, that my knees will hit the floor. I am not a fan of the fact that this bar seems to rely on the flat horizontal bar on the back to grab a hold of the molding on the top of the door way. Mainly because molding is not meant to support weight. Which is my reasoning for installing the brackets. I am no little guy, being 6 foot tall and 284 lbs, makes me a little skidish about relying on a piece of molding to help support me.
Beyond all of that....If I were to rate this bar purely on its function. Then, it would score a perfect 5 stars. I took it to a friends house, who has what would probably be considered a more standard door way opening. The height is better, it fits to the door way better, and it is a great way to do pull ups in your home. Over time, it may cause some minor damage, but new molding would probably be the only repair or some paint on the back side of the door way where the horizontal bar rests.
Bottom line, if you walls are constructed with 2 X 4''s and you have a more standard door way opening you will not have any troubles other then maybe some assembly issues. But if your walls were constructed using 2 X 3''s and the opening is what may be considered smaller then the standard, you will either not want to buy this or you will modify it to work. I will post my modification if I am able. If you live in an old farm house, with very large door ways. Pass on this and either construct a pull up bar outside, or find some way to mount a more permanent bar in the opening.
Buy Maximum Fitness Gear All-In-One Doorway Chin-Up Bar with Ab Exercise Guide Now
I was going to buy the Iron Gym Extreme Edition, but found that it would not fit my doors (glad I measured before I ordered). Luckily, I found this pull-up bar, as it was supposed to fit larger door frames and cost about the same. The reviews seemed good, so I gave it a shot.After using it for a month, I could not be happier with it. It is a cinch to set up and take down. I don''t use the brackets included, but it still seems very sturdy. I''m not at all worried about it falling off the door. I weighed 250lbs. when I first started using the bar so I can''t speak to the 300lb. weight limit. However, as I said it is very sturdy and not once have I felt unsafe.
As other reviewers have said, it requires some assembly, and comes with no tools. I put it together with a screwdriver and a pair of pliers. Easy peasy, done in about 20 minutes.
The only other thing worth mentioning is that it does leave small black marks as some have said. They''re hardly noticeable (I don''t), but they are there.
All in all, great product.
Read Best Reviews of Maximum Fitness Gear All-In-One Doorway Chin-Up Bar with Ab Exercise Guide Here
I''ve used this product for almost a year now for P90X/P90X+ and it has worked great, but it also depends on whether you have a good door frame for it. I''m 6''2" ,weigh just over 200 lbs, and initially I just used the bar ''as is'' in my living room door frame. It wasn''t long however that I realized that the side pieces (that rest on the front sides of the door frame where there is typically trim) had worn through multiple layers of paint, chipping them off, and eventually digging down into the wood fibers of the molding and grinding them away.Here''s how to avoid this: Take a couple of hand towels (that you might normally use as sweat rags), fold them long and skinny and wrap them tightly around the side pieces and then wrap tape around them multiple times to hold the wrapping in place. Duck tape is probably best but I used painters tape and its been fine. This will cushion those side pieces and protect your trim. I also tried foam pipe insulation, but that quickly eats away and you have to continuously replace it. This way will stay in place and you won''t have to keep messing with it. This should be plenty stable assuming you have a good door frame, and the part of the bar that reaches under and grips the top of the door frame can still make a good hold. I recently moved and this is no longer the case for any of my door frames, so I may have to try one of the other bars.
SAFETY NOTE: When testing this bar in a door frame, once you put all your weight on the bar for the 1st time, keep the bottoms of your feet facing the floor in case the bar slips while hanging, you''ll have a better chance of landing the right way. I''ve done the instinctive thing which is to bend the knees while hanging, big mistake, I landed on my knee caps pretty hard. Once you know its a good door frame and the bar is stable, you should be to do whatever you want with your legs and not worry about it.
Want Maximum Fitness Gear All-In-One Doorway Chin-Up Bar with Ab Exercise Guide Discount?
I read the negative reviews of how some people received bent products that caused the bar to be uneven when assembled and I ignored them. Please don''t ignore them, I''m another recipient of the poor product quality inherent in this item. I assembled it and mounted it in my doorway, and the bar was easily 2 inches higher on the left than the right. I thought my doorway might have been off, so I tried it in 3 other doorways, same thing happened. Don''t invest in this product if you want a chin up bar that''s level (and let''s face it, you can''t use a chin up bar reliably and safely that isn''t!)

0 comments:
Post a Comment